Screaming Chicken

These are pre-cut sections of vinyl designed for wrapping the small chrome section below the DRL lights on the 2016-18 Camaro SS. No cutting or trimming required. Includes 2 each of both driver...

These 2016-24 Camaro Javelin side stripes accent the upper body line of the car. This kit includes front fender, door and rear fender sections for both sides of the car. These are pre-cut at the door...

These 2016-24 Camaro side stripes start behind the front wheel opening and extend toward the end of the door. They are pre-cut for easier install, no cutting or trimming required. Available for all...

These 2016-24 Camaro rocker stripes have a larger middle section with a pinstripe going around the outside edge, accents the lower body lines of the car. Wraps around edge slightly at door...

These Camaro stripes start behind the front wheel opening and extend toward the end of the door. They have a solid center section with a pinstripe going around. These are pre-cut for the door opening...

This stripe is a solid stripe that goes on the lower front fender and door for all 2010-15 Camaros. It accents the lower body lines of the car. They are pre-cut and require no trimming. Include front...

This is lettering for the side of the cowl on your hood. We include 3 of the stickers, so you'll have 1 extra. These fit hoods with stripes or no stripes. Choose from SS, RS, LS, LS3, 6.2 Litre or...

These 2010-15 Camaro gill stripes install over the factory gill/vent indention & are available in two different designs (gill #1 or gill #2). 1 set includes both the Driver & Passenger sides...

These Camaro side stripes were inspired by the graphics that appeared on early COPO concept cars. These quarter panel stripes extend lower on the quarter panel. No cutting or trimming required,...

3D printed dual drink holder for all 1982-92 Camaros. Drink holder installs with no cutting or drilling. The mounting bracket/ring is molded to ‘interlock’ over the right side of the...

3D printed drink holder for all 1982-92 Camaros available in two sizes (Slim or XL). Drink holder installs with no cutting or drilling. The mounting bracket/ring is molded to...

Includes 8 nuts for both front seats on all 1982-92 Camaros & Firebirds. Nuts are very similar to the factory hardware, M8 nuts with free spinning attached washers. Easy to lose while seats are...