Engine/Drivetrain

This Detroit Speed bracket mounts the GM hydraulic clutch master cylinder to the firewall of the 1967-69 Camaro/Firebirds. The bracket correctly positions itself by mounting between the firewall and brake master cylinder or brake booster on power brake...

Pre-assembled chrome hood safety latch for 1967-81 Camaros. Accurate reproduction from new proprietary tooling. Hood safety latch is properly pre-assembled for easy installation. Assembly includes lock plate, pilot bolt, spring, retainer and jamb nut...

LG Billet USA made 1967-81 Camaro hood latch assembly. Machined base from 6061 billet aluminum to increase the look over the factory stamped steel part. Stainless steel collar, spring, catch pin and hardware necessary for installation included. Available...

Pre-assembled hood safety latch for 1967-81 Camaros. Accurate reproduction from new proprietary tooling. Hood safety latch is properly pre-assembled for easy installation. Assembly includes lock plate, pilot bolt, spring, retainer and jamb nut. Will not...

Includes all the needed hardware to install gas tank straps in 1967-69 Camaros & Firebirds. Does not include the straps or the gas tank. A quantity of one will be everything for one car. 

ARP stainless steel header bolts are 15 percent stronger than Grade 8 steel. These bolts have a compact head that will allow a socket to fit into those tight, tricky spaces next to the headers. These bolts are both highly corrosion-resistant and...

ARP manufactures a variety of header bolt kits to facilitate the installation of your headers. Rated at 170,000 psi, they're much stronger than stock and will last under even the most severe conditions. Each kit includes 12 bolts for complete set, plus...

1967-69 Camaro/Firebird LS Swap Engine Mounts from Holley allow any LS based engine to be installed with a stock sub frame. Oil Pan part #302-2 will clear frame with these mounts as well as Holley headers and crossmember. The mounts use rubber or...

Aluminum plate that covers the factory hole in the firewall on all 1967-69 Camaros/Firebirds where the factory gas pedal mounts for cars that have been swapped to DBW.  This kit includes a cnc machined plate made from 6061-T6 aluminum that is powder...

1967-92 Camaro/Firebird SBC Mechanical Fuel Pump Install Kit includes the gaskets/hardware you need to install a mechanical fuel pump on your small block Chevy V8 engine. Includes Chevrolet Performance Push Rod, ARP Hex Fuel Pump Bolt Kit, Zinc coated...

1 Inch plastic plug used for 1967-69 Camaros & Firebirds with factory 4-Speed to plug standard speedometer cable hole in firewall. Works great when using a GPS based speedometer. There are many other application for this plug that will fill any 1"...

Aluminum water necks fit most Chevrolet V8's with a 90 degree neck. Two-piece design necks swivel 360 degrees to accommodate LH and RH radiator inlets. An O-ring seal and two chrome plated socket head cap screws are included.Product includes: water neck,...