LS Swaps

This Detroit Speed bracket mounts the GM hydraulic clutch master cylinder to the firewall of the 1967-69 Camaro/Firebirds. The bracket correctly positions itself by mounting between the firewall and brake master cylinder or brake booster on power brake...

The Detroit Speed Inc, C6 Throttle Pedal Bracket is designed as a bolt-on bracket that mounts a C6 Corvette electronic throttle pedal to the firewall in a 1967-69 Camaro/Firebird. The bracket has a black e-coat finish and comes with all required hardware...

This bracket from Modo Innovations adapts your factory 1967-69 Camaro/Firebird gas pedal to the CTS (GMPP) drive by wire accelerator pedal sensor.  This product uses your factory pedal, spring and pin or add new parts to your order.  This...

This is a DBW (drive by wire) accelerator pedal adapter plate that fits 1967-69 Camaros & Firebirds. It is cnc machined from 6061-T6 aluminum and powder coated in satin black (made in the USA). This kit comes with the hardware to mount the C6...

HINSON Motorsports is proud to release these protective spark plug boots made for LS engines (LS1 and LS3). These boots are designed to protect the spark plug wire and boot from damage due to the exhaust heat. They will also provide some protection to...

Made in the USA by Hinson Motorsports, these 8.5 mm spark plug wires use MSD 500 ohm per foot wire and have been assembled to correct length for LS engines with headers. Positive connection with GM ignition coils and durable plug boots. Don't...

ARP manufactures some of the best quality header bolt kits to facilitate the installation of your headers. Rated at 170,000 psi, they're much stronger than stock and will last under even the most severe conditions. Each kit includes the parts required...

Includes one LSX emblem approximately 4.75" wide by 1.6" tall  emblem. Has adhesive on backside for easy install - can be installed on any flat metal, glass or smooth plastic surface. Works great on a car, refrigerator or tool box. Emblems are...

1967-69 Camaro/Firebird LS Swap Engine Mounts from Holley allow any LS based engine to be installed with a stock sub frame. Oil Pan part #302-2 will clear frame with these mounts as well as Holley headers and crossmember. The mounts use rubber or...

Aluminum plate that covers the factory hole in the firewall on all 1967-69 Camaros/Firebirds where the factory gas pedal mounts for cars that have been swapped to DBW.  This kit includes a cnc machined plate made from 6061-T6 aluminum that is powder...

18mm o2 sensor plug works great for relocating a sensor to a better location, allows you to plug existing hole without welding or replacing exhaust.Product includes: 18mm o2 sensor plug

Aluminum adapters allow bolting an early GM 3-bolt motor mount to the late model LS style block with a 4-bolt pattern. Adapters place the early mount in approximately the same location as found on the original SB/BB Chevy engines and also features...