LS Swaps

Includes one LSX emblem approximately 4.75" wide by 1.6" tall  emblem. Has adhesive on backside for easy install - can be installed on any flat metal, glass or smooth plastic surface. Works great on a car, refrigerator or tool box. Emblems are...

Aluminum adapters allow bolting an early GM 3-bolt motor mount to the late model LS style block with a 4-bolt pattern. Adapters place the early mount in approximately the same location as found on the original SB/BB Chevy engines and also features...

The yellow handle on the GM dipstick isn't too attractive, these billet dipstick handles from Lokar are a big improvement. With their billet aluminum handle and E-Z read flexible inner cable, Lokar's direct-mount engine dipstick handles are an ideal...

The plastic oil cap on the LS engine is brittle and often fades after a few years. More often than not, this cap has already been replaced multiple times. To prevent wasting your money on plastic junk, LG Billet USA developed a billet oil cap for your...

HINSON Motorsports is proud to release these protective spark plug boots made for LS engines (LS1 and LS3). These boots are designed to protect the spark plug wire and boot from damage due to the exhaust heat. They will also provide some protection to...

Stainless Steel Engine Oil Drain Plug for LS and LT (2016 & newer) engines will pull unwanted metals out of your motor oil resulting in longer engine life. According to General Motors, by using bypass filters you could get the micron size...

ARP manufactures some of the best quality header bolt kits to facilitate the installation of your headers. Rated at 170,000 psi, they're much stronger than stock and will last under even the most severe conditions. Each kit includes the parts required...

The Dakota Digital PAC-2800BT was designed for the ultimate in flexibility and to be a simple add-on in any application using an electric fan. Included is a 70amp relay, enough for even the most power hungry of cooling fans. Fully programmable,...

18mm o2 sensor plug works great for relocating a sensor to a better location, allows you to plug existing hole without welding or replacing exhaust.Product includes: 18mm o2 sensor plug

Made in the USA by Hinson Motorsports, these 8.5 mm spark plug wires use MSD 500 ohm per foot wire and have been assembled to correct length for LS engines with headers. Positive connection with GM ignition coils and durable plug boots. Don't...