Miscellaneous Interior

Made from aluminum, this bracket allows you to install switches in your ash tray in all 1982-92 Camaros. Bracket comes with no holes or with holes pre-drilled (3 or 4). The pre-drilled holes are 16 mm in diameter and can be enlarged for bigger buttons...

3D printed dual drink holder for 1982-92 Firebirds, different versions for 1982-84 & 1985-92 . Drink holder installs with no cutting or drilling. All you need to do is remove the metal insert inside your ashtray, then snap in the drink holder...

3D printed dual drink holder for all 1982-92 Camaros. Drink holder installs with no cutting or drilling. The mounting bracket/ring is molded to ‘interlock’ over the right side of the existing center console. Ash tray functionality is...

3D printed drink holder for all 1982-92 Camaros available in two sizes (Slim or XL). Drink holder installs with no cutting or drilling. The mounting bracket/ring is molded to ‘interlock’ over the right side of the existing center console...

This pin attaches the throttle pedal to the rod. This pin is easy to misplace during a restoration. Correct for all 1982-92 & 1993-2002 Camaros/Firebirds.Product Includes: pin only

Reproduction hatch screw for 1982-92 Camaros & Firebirds. These plastic screws attach the rear hatch interior panels, they thread into retainers. Original GM have been discontinued. Available as a single, 6 pack or 8 pack (cheaper per retainer when...

Reproduction hatch screw retainer for all 1982-92 Camaros & Firebirds. These plastic retainers go behind the rear hatch interior panels, the large interior colored screws thread into them. Original GM have been discontinued, these work much better...

New Genuine GM Part # 3817880 Brake Clevis Pin Retainer. This clip is used to keep the brake actuating rod clevis pin in place on all 1982-2002 Camaros & Firebirds. For use with a 3/8" pin with retaining "slot". Will not work older cotter...

Pedal Assembly Shaft Bushings prevent metal on metal contact for smoother brake operation. The plastic becomes brittle over the years and falls out, these replacement bushings for 1982-92 Camaros & Firebirds restore your pedals to like new. For...

Have you swapped to a 1997-2002 4th gen center console in your 1985-92 Firebird? This bracket allows you to mount your power window switches where the 4th gen console has an ashtray. Bracket is 3d printed in ASA with an easy snap in design, the lid...

Is your 1982-92 Camaro radio no longer working or being used? This 1/8" thick aluminum panel takes the place of your radio. It is sturdy enough to mount switches or attach an emblem. We have it available in 3 different finishes - matte black powdercoat,...

Is your 1982-92 Camaro/Firebird AC & Heater controller no longer working or being used? This 1/8" thick aluminum panel takes the place of your Heat/AC controller. It is sturdy enough to mount switches or attach an emblem. We have it available in 3...