Drivetrain & Brakes

New brake caliper bolts for 2016-24 Camaro SS or ZL1. Same strength rating and quality as originals, except these are not torque to yield so they can be reused when servicing brakes. Great item to replace when installing new rotors. Also feature a...

New brake caliper bolts for 2010-15 Camaro SS and ZL1. Same strength rating and quality as originals, except these are not torque to yield so they can be reused during brake servicing. Also feature a slightly larger bolt head so washers are not needed...

The plastic oil cap on the 2010-15 Camaro V8 LS engine is brittle and often fades after a few years. More often than not, this cap has already been replaced multiple times. To prevent wasting your money on plastic junk, LG Billet USA developed a billet...

A pack of four replacement crush washers for the magnetic drain plugs. The manufacturer of the magnetic drain plug recommends changing the crush washer when you change your oil.

2010-15 Camaro Stainless Steel Engine Oil Drain Plug with Neodymium Magnet will pull unwanted metals out of your motor oil resulting in longer engine life. According to General Motors, by using bypass filters you could get the micron size of...

2016-24 Camaro Stainless Steel Engine Oil Drain Plug with Neodymium Magnet will pull unwanted metals out of your motor oil resulting in longer engine life. According to General Motors, by using bypass filters you could get the micron size of...

Get rid of that annoying first-to-fourth "skip-shift" GM incorporates into manual transmission 2016-24 Camaros with this Skip-Shift Eliminator. This plug in piece requires no additional modifications to your vehicle. Skip shift light on the dash will...

Get rid of that annoying first-to-fourth "skip-shift" GM incorporates into manual transmission 2010-15 Camaros with this Skip-Shift Eliminator. This plug in piece requires no additional modifications to your vehicle. Skip shift light on the dash will...

The yellow handle on the 2010-15 Camaro GM dipstick isn't too attractive, these billet dipstick handles from Lokar are a big improvement. With their billet aluminum handle and E-Z read flexible inner cable, Lokar's direct-mount engine dipsticks are...

Made in the USA by Hinson Motorsports, these 8.5 mm spark plug wires use MSD 500 ohm per foot wire and have been assembled to correct length for LS engines with headers. Positive connection with GM ignition coils and durable plug boots. Don't...

HINSON Motorsports is proud to release these protective spark plug boots made for LS engines (LS1 and LS3). These boots are designed to protect the spark plug wire and boot from damage due to the exhaust heat. They will also provide some protection to...

ARP manufactures some of the best quality header bolt kits to facilitate the installation of your headers. Rated at 170,000 psi, they're much stronger than stock and will last under even the most severe conditions. Each kit includes the parts required...